ZXR10 GER (V2.6.03) General Excellent Router User Manual Volume-I
162 Confidential and Proprietary Information of ZTE CORPORATION
Each dynamic routing protocol has a default administrative
distance, as listed in
Table 202 . If static route to be overridden
by information from a dynamic routing protocol, simply ensures
that the administrative distance of the static route is higher than
that of the dynamic protocol.
TABLE 202 DEFAULT ADMINISTRATIVE DISTANCE
Static routes that point to an interface is advertised via RIP,
IGRP and other dynamic routing protocols, regardless of whether
redistribute static router configuration commands were specified
for those routing protocols. These static routes are advertised
because static routes that point to an interface are considered in
the routing table to be connected and hence lose their static
nature. In a routing environment where there are multiple
routers and multiple paths, it is very complicated to configure
static routes.
When an interface goes down, all static routes through that
interface are removed from IP routing table. Also, when router
operating system (ROS) can no longer find a valid next hop for
the address specified as the address of the forwarding router in
a static route, the static route is removed from the IP routing
table.
This procedure describes how to do static route configuration on
ZTE ZXR10 GER.
Router Command Line Interface has been accessed.
1. Enter into configuration mode by writing config terminal
command in global configuration mode as shown in
Table
203.
Route Source Default Distance
Connected interface 0
Static Route 1
Enhanced IGRP (EIGRP) summary route 5
Exterior Border Gateway Protocol (BGP) 20
Internal EIGRP 90
IGRP 100
OSPF 110
IS-IS 115
RIP 120
EIGRP external route 170
Interior BGP 200
Unknown 255
Advertisement
Redistribute
Static
Purpose
Prerequisite
Steps