Zte ZXR10 GER - DIS & Router Priority; Basic IS-IS Configuration

Chapter 14 OSPF Configuration
Confidential and Proprietary Information of ZTE CORPORATION 191
Command
Format
Command
Mode
Command Function
router ospf
<process-id>
Global This enables OSPF routing
process
Result: This initiates the OSPF process in router. OSPF
process-id is a numeric value local to the router.
3. Assigning areas to interfaces using network <network or IP
address> <mask> <areaid> command in global
configuration mode as shown in
Table 231.
TABLE 231 OSPF NETWORK COMMAND
Command
Format
Command
Mode
Command Function
network
<ip-
address>
<wildcard-
mask> area
<area-id>
OSPF Route
This defines interfaces on which
OSPF protocol runs and defines
an area ID for these interfaces
(if area does not exist, the
system will automatically an
area)
Result: This assigns an interface to certain area. Mask is
used for shortcut, it puts list of interfaces in same area with
one line configuration command.
1. For OSPF cost, use ip ospf cost <cost> command in OSPF
interface mode as shown in
Table 232.
TABLE 232 IP OSPF COST COMMAND
Command
Format
Command
Mode
Command Function
ip ospf
cost
<cost>
OSPF
Interface
This configures interface cost in
explicit mode
Result: This explicitly specifies the cost of sending a packet
on an OSPF interface.
2. For OSPF link state advertisements for an interface, use ip
ospf retransmit-interval <seconds> command in OSPF
interface mode as shown in
Table 233.
TABLE 233 IP OSPF RETRANSMIT INTERVAL COMMAND
Command
Format
Command
Mode
Command Function
ip ospf
retransmit-
interval
<seconds>
OSPF Interface
This designates the interval
for an interface to retransmit
LSA
OSPF Interface
Attributes