EasyManua.ls Logo

Zte ZXR10 GER - Configuring Global IS-IS Parameters

Zte ZXR10 GER
412 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ZXR10 GER (V2.6.03) General Excellent Router User Manual Volume-I
192 Confidential and Proprietary Information of ZTE CORPORATION
Result: This specifies the number of seconds between
link-state advertisement (LSA) retransmissions for
adjacencies belonging to an OSPF interface.
3. For sending LSA update packet to on an OSPF interface, use
ip ospf transmit-delay <seconds> command in OSPF
interface mode as shown in
Table 234.
TABLE 234 IP OSPF TRANSMIT DELAY
Command
Format
Command
Mode
Command Function
ip ospf
transmit-delay
<seconds>
OSPF
Interface
This designates delay for
an interface to transmit a
link state update packet
Result: This sets estimated number of seconds required to
send a link-state update packet on an OSPF interface.
4. For OSPF designated router in a network, use ip ospf
priority <seconds> command in OSPF interface mode as
shown in
Table 235.
TABLE 235 IP OSPF PRIORITY
Command
Format
Command
Mode
Command Function
ip ospf priority
<number>
OSPF Interface
This configures interface
priority
Result: This sets priority to help determine the OSPF
designated router for a network.
5. For OSPF device that must wait for hello packet of other
router, use ip ospf dead-interval <seconds> command in
interface mode as shown in
Table 236.
TABLE 236 IP OSPF DEAD-INTERVAL COMMAND
Command
Format
Command
Mode
Command Function
ip ospf dead-
interval
<seconds>
OSPF
Interface
This designates the dead
interval of the neighbor on an
interface
Result: This sets the number of seconds that a device must
wait before it declares a neighbor OSPF router down because
this has not received a hello packet.
E
ND OF STEPS
Example: As shown in Figure 87, OSPF runs on routers R1 and
R2, and network is divided into three areas.

Table of Contents

Related product manuals