clear interface 109
clear interface Removes an IP interface.
Syntax — clear interface vlan-id ip
■ vlan-id — VLAN name or number
Defaults — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — If the interface you want to remove is configured as the system
IP address, removing the address can interfere with system tasks that use
the system IP address, including the following:
■ Mobility domain operations
■ Topology reporting for dual-homed MAP access points
■ Default source IP address used in unsolicited communications such as
AAA accounting reports and SNMP traps
Examples — The following command removes the IP interface
configured on VLAN mauve:
WX1200# clear interface mauve ip
success: cleared ip on vlan mauve
See Also
■ “set interface” on page 135
■ “set interface status” on page 136
■ “display interface” on page 118
“set snmp trap receiver” on page 153
“clear snmp trap receiver” on page 114
Ping “ping” on page 131
Telnet Client “telnet” on page 158
Traceroute “traceroute” on page 159
Table 25 IP Services Commands by Usage (continued)
Type Command
To Next Page
Loading...
