58 CHAPTER 4: PORT COMMANDS
clear dap Removes a Distributed MAP.
CAUTION: When you clear a Distributed MAP, MSS ends user sessions
that are using the MAP.
Syntax —
clear dap dap-num
■ dap-num — Number of the Distributed MAP(s) you want to remove.
Defaults — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Examples — The following command clears Distributed MAP 1:
WX4400# clear dap 1
This will clear specified DAP devices.
Would you like to continue? (y/n) [n]y
See Also
■ “set dap” on page 73
■ “set port type ap” on page 82
clear port counters Clears port statistics counters and resets them to 0.
Syntax — clear port counters
Defaults — None.
Port Groups “set port-group” on page 76
“display port-group” on page 63
“clear port-group” on page 59
Statistics “display port counters” on page 62
“monitor port counters” on page 68
“clear port counters” on page 58
Table 9 Port Commands by Usage (continued)
Type Command
To Next Page
Loading...
