clear spantree statistics 319
History — Introduced in MSS Version 3.0.
Usage — MSS does not change a port’s priority for VLANs other than the
one(s) you specify.
Examples — The following command resets the STP priority for port 2 in
VLAN avocado:
WX4400# clear spantree portvlanpri 2 vlan avocado
success: change accepted.
See Also
■ “clear spantree portpri” on page 317
■ “display spantree” on page 320
■ “set spantree portpri” on page 337
■ “set spantree portvlanpri” on page 339
clear spantree
statistics
Clears STP statistics counters for a network port or ports and resets them
to 0.
Syntax —
clear spantree statistics port-list [vlan vlan-id]
■ port-list — List of ports. Statistics counters are reset on the
specified ports.
■ vlan vlan-id — VLAN name or number. MSS resets statistics
counters for only the specified VLAN.
Defaults — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Examples — The following command clears STP statistics counters for
ports 1, 3, and 5 through 8, for all VLANs:
WX1200# clear spantree statistics 1,3,5-8
success: change accepted.
See Also
■ “display spantree statistics” on page 325
To Next Page
Loading...
