3Com 3CRWX120695A - Set Dot1 X Tx-Period

432 CHAPTER 15: 802.1X MANAGEMENT COMMANDS
Syntax — set dot1x timeout supplicant seconds
■ seconds — Specify a value between 1 and 65,535.
Defaults — The default is 30 seconds.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Examples — Type the following command to set the number of seconds
for authentication session timeout to 300:
WX4400# set dot1x timeout supplicant 300
success: dot1x supplicant timeout set to 300.
See Also
■ “display dot1x” on page 421
■ “clear dot1x timeout auth-server” on page 419
set dot1x tx-period Sets the number of seconds that must elapse before the WX switch
retransmits an EAPoL packet.
Syntax —
set dot1x tx-period seconds
■ seconds — Specify a value between 1 and 65,535.
Defaults — The default is 5 seconds.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Examples — Type the following command to set the number of seconds
before the WX switch retransmits an EAPoL packet to 300:
WX4400# set dot1x tx-period 300
success: dot1x tx-period set to 300.
See Also
■ “display dot1x” on page 421
■ “clear dot1x tx-period” on page 420