3Com 3CRWX120695A - Display Auto-Tune Neighbors

248 CHAPTER 9: MANAGED ACCESS POINT COMMANDS
■ “set {ap | dap} radio auto-tune max-power” on page 266
■ “set {ap | dap} radio auto-tune max- retransmissions” on page 267
■ “set radio-profile auto-tune channel-config” on page 276
■ “set radio-profile auto-tune channel-holddown” on page 277
■ “set radio-profile auto-tune channel-interval” on page 278
■ “set radio-profile auto-tune power-backoff- timer” on page 279
■ “set radio-profile auto-tune power-config” on page 280
■ “set radio-profile auto-tune power-interval” on page 281
display auto-tune
neighbors
Displays the other 3Com radios and third-party 802.11 radios that a
3Com radio can hear.
Syntax —
display auto-tune neighbors
[ap map-num [radio {1 | 2| all}]]
Syntax — display auto-tune neighbors
[dap dap-num [radio {1 | 2| all}]]
■ map-num — MAP port connected to the MAP access point for which to
display neighbors.
■ dap-num — Number of a Distributed MAP for which to display
neighbors.
■ radio 1 — Shows neighbor information for radio 1.
■ radio 2 — Shows neighbor information for radio 2. (This option does
not apply to single-radio models.)
■ radio all — Shows neighbor information for both radios.
Defaults — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — For simplicity, this command displays a single entry for each
3Com radio, even if the radio is supporting multiple BSSIDs. However,
BSSIDs for third-party 802.11 radios are listed separately, even if a radio is
supporting more than one BSSID.