66 CHAPTER 4: PORT COMMANDS
Examples — The following command displays the preference settings on
all four ports of a WX4400 switch:
WX4400# display port preference
Port Preference
===========================================================
1 GBIC
2 RJ45
3 GBIC
4 GBIC
Table 13 describes the fields in this display.
See Also
■ “clear port preference” on page 60
■ “set port preference” on page 80
display port status Displays configuration and status information for ports.
Syntax — display port status [port-list]
■ port-list — List of physical ports. If you do not specify a port list,
information is displayed for all ports.
Defaults — None.
Access — All.
History — Introduced in MSS Version 3.0.
Table 13 Output for display port preference
Field Description
Port Port number.
Preference Preference setting:
■ GBIC — The GBIC (fiber) interface is selected as
the active interface.
■ RJ45 — The RJ-45 (copper) interface is selected
as the active interface.
To Next Page
Loading...
