set system ip-address 53
Default — The factory default country code is None.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — You must set the system county code to a valid value before
using any set ap commands to configure a MAP.
Examples — To set the country code to Canada, type the following
command:
WX1200# set system country code CA
success: change accepted.
See Also
■ “display config” on page 470
set system
ip-address
Sets the system IP address so that it can be used by various services in the
WX switch.
CAUTION: Any currently configured Mobility Domain operations cease if
you change the IP address. If you change the address, you must reset the
Mobility Domain.
Syntax —
set system ip-address ip-addr
■ ip-addr — IP address, in dotted decimal notation.
South Korea KR
Spain ES
Sweden SE
Switzerland CH
Taiwan TW
Thailand TH
United Arab Emirates AE
United Kingdom GB
United States US
Table 8 Country Codes (continued)
Country Code
To Next Page
Loading...
