504 CHAPTER 21: BOOT PROMPT COMMANDS
■ “delete” on page 505
■ “display” on page 507
■ “next” on page 511
create Creates a new boot profile. (For information about boot profiles, see
“display” on page 507.)
Syntax —
create
Defaults — The new boot profile has the same settings as the currently
active boot profile by default.
Access — Boot prompt.
History — Introduced in MSS Version 3.0.
Usage — A WX switch can have up to four boot profiles. The boot
profiles are stored in slots, numbered 0 through 3. When you create a
new profile, the system uses the next available slot for the profile. If all
four slots already contain profiles and you try to create a fifth profile, the
switch displays a message advising you to change one of the existing
profiles instead.
To make a new boot profile the currently active boot profile, use the next
command. To change boot parameter settings, use the change
command.
Examples — The following command creates a new boot profile in slot 1
on a WX switch that currently has only one boot profile, in slot 0:
boot> create
BOOT Index: 1
BOOT TYPE: c
DEVICE: boot1:
FILENAME: default
FLAGS: 00000000
OPTIONS: run=nos;boot=0
See Also
■ “change” on page 503
■ “delete” on page 505
To Next Page
Loading...
