3Com 3CRWX120695A - Using RF Planning; Overview

clear ntp server 113
■ “set ip telnet” on page 146
■ “set ip telnet server” on page 146
clear ntp server Removes an NTP server from a WX switch configuration.
Syntax — clear ntp server {ip-addr | all}
■ ip-addr — IP address of the server to remove, in dotted decimal
notation.
■ all — Removes all NTP servers from the configuration.
Defaults — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Examples — The following command removes NTP server
192.168.40.240 from a WX switch configuration:
WX4400# clear ntp server 192.168.40.240
success: change accepted.
See Also
■ “clear ntp update-interval” on page 113
■ “display ntp” on page 125
■ “set ntp” on page 147
■ “set ntp server” on page 148
■ “set ntp update-interval” on page 149
clear ntp
update-interval
Resets the NTP update interval to the default value.
Syntax — clear ntp update-interval
Defaults — The default NTP update interval is 64 seconds.
Access — Enabled.
History — Introduced in MSS Version 3.0.