364 CHAPTER 11: IGMP SNOOPING COMMANDS
See Also
■ “display igmp receiver-table” on page 351
set igmp rv Changes the robustness value for one VLAN or all VLANs on a WX.
Robustness adjusts the IGMP timers to the amount of traffic loss that
occurs on the network.
Syntax —
set igmp rv num [vlan vlan-id]
■ num — Robustness value. You can specify a value from 2 through 255.
Set the robustness value higher to adjust for more traffic loss.
■ vlan vlan-id — VLAN name or number. If you do not specify a
VLAN, MSS changes the robustness value for all VLANs.
Defaults — The default robustness value for all VLANs is 2.
Access — Enabled.
History — Introduced in MSS Version 3.0.
See Also
■ “set igmp oqi” on page 359
■ “set igmp qi” on page 360
■ “set igmp qri” on page 361
To Next Page
Loading...
