3Com 3CRWX120695A - Set Spantree Maxage

set spantree maxage 335
■ vlan vlan-id — VLAN name or number. MSS changes the interval on
only the specified VLAN.
Defaults — The default hello timer interval is 2 seconds.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Examples — The following command changes the hello interval for all
VLANs to 4 seconds:
WX4400# set spantree hello 4 all
success: change accepted.
See Also
■ “display spantree” on page 320
set spantree
maxage
Changes the maximum age for an STP root bridge hello packet that is
acceptable to a wireless LAN switch acting as a designated bridge on one
or all of its VLANs. After waiting this period of time for a new hello
packet, the WX switch determines that the root bridge is unavailable and
issues a topology change message.
Syntax —
set spantree maxage aging-time {all | vlan vlan-id}
■ aging-time — Maximum age value. You can specify from 6 through
40 seconds.
■ all — Changes the maximum age on all VLANs.
■ vlan vlan-id — VLAN name or number. MSS changes the maximum
age on only the specified VLAN.
Defaults — The default maximum age for root bridge hello packets is 20
seconds.
Access — Enabled.
History — Introduced in MSS Version 3.0.