406 CHAPTER 14: RADIUS AND SERVER GROUP COMMANDS
Defaults — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Examples — The following command removes the RADIUS server rs42
from a list of remote AAA servers:
WX4400# clear radius server rs42
success: change accepted.
See Also
■ “display aaa” on page 180
■ “set radius server” on page 409
clear server group Removes a RADIUS server group from the configuration, or disables load
balancing for the group.
Syntax —
clear server group group-name [load-balance]
■ group-name — Name of a RADIUS server group configured to perform
remote AAA services for WX switches.
■ load-balance — Ability of group members to share demand for
services among servers.
Defaults — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — Deleting a server group removes the server group from the
configuration. However, the members of the server group remain.
Examples — To remove the server group sg-77 type the following
command:
WX4400# clear server group sg-77
success: change accepted.
To Next Page
Loading...
