clear rfdetect ignore 451
commands, RF detection returns to the default handling of
countermeasures. Consequently, the rogue you cleared can still be
attacked if it is still in the rogue list. To stop countermeasures against a
device, add the device to the known addresses list using the set rfdetect
ignore command.
Examples — The following command removes rogue BSSID
aa:bb:cc:11:22:33 from the list configured by the set rfdetect
countermeasures mac command:
WX1200# clear rfdetect countermeasures mac aa:bb:cc:11:22:33
success: clear rfdetect countermeasures mac
aa:bb:cc:11:22:33
See Also
■ “display rfdetect ignore” on page 455
■ “set rf detect countermeasures” on page 459
■ “set rfdetect countermeasures mac” on page 460
■ “set rfdetect ignore” on page 461
clear rfdetect
ignore
Removes a device from the ignore list for RF scans. MSS does not
generate log messages or traps for the devices in the ignore list.
Syntax —
clear rfdetect ignore mac-addr
■ mac-addr — Basic service set identifier (BSSID), which is a MAC
address, of the device to remove from the ignore list.
Defaults — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Examples — The following command removes BSSID aa:bb:cc:11:22:33
from the ignore list for RF scans:
WX1200# clear rfdetect ignore aa:bb:cc:11:22:33
success: aa:bb:cc:11:22:33 is no longer ignored.
To Next Page
Loading...
