clear vlan 91
The following command clears all dynamic forwarding database entries
that match all VLANs:
WX4400# clear fdb dynamic
success: change accepted.
The following command clears all dynamic forwarding database entries
that match ports 3 and 5:
WX4400# clear fdb port 3,5
success: change accepted.
See Also
■ “display fdb” on page 92
■ “set fdb” on page 101
clear vlan Removes physical or virtual ports from a VLAN or removes a VLAN
entirely.
CAUTION:
When you remove a VLAN, MSS completely removes the
VLAN from the configuration and also removes all configuration
information that uses the VLAN. If you want to remove only a specific
port from the VLAN, make sure you specify the port number in the
command.
Syntax —
clear vlan vlan-id [port port-list [tag tag-value]]
■ vlan-id — VLAN name or number.
■ port port-list — List of physical ports. MSS removes the specified
ports from the VLAN. If you do not specify a list of ports, MSS removes
the VLAN entirely.
■ tag tag-value — Tag number that identifies a virtual port. MSS
removes only the specified virtual port from the specified physical
ports.
Default — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.
To Next Page
Loading...
