3Com 3CRWX120695A - Display Security Acl Info

372 CHAPTER 12: SECURITY ACL COMMANDS
Examples — To display the security ACL hits on a WX switch, type the
following command:
WX4400# display security acl hits
ACL hit-counters
Index Counter ACL-name
----- -------------------- --------
1 0 acl_2
2 0 acl_175
3 916 acl_123
See Also
■ “hit-sample-rate” on page 378
■ “set security acl” on page 380
display security acl
info
Displays the contents of a specified security ACL or all security ACLs that
are committed — saved in the running configuration and nonvolatile
storage — or the contents of security ACLs in the edit buffer before they
are committed.
Syntax —
display security acl info {acl-name | all}
[editbuffer]
■ acl-name — Name of an existing security ACL to display. ACL names
must start with a letter and are case-insensitive.
■ all — Displays the contents of all security ACLs.
■ editbuffer — Displays the contents of the specified security ACL or
all security ACLs that are stored in the edit buffer after being created
with set security acl. If you do not use this parameter, only
committed ACLs are shown.
Defaults — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.