3Com 3CRWX120695A - Set Spantree

332 CHAPTER 10: STP COMMANDS
Examples — The following command shows uplink fast convergence
information for all VLANs:
WX4400# display spantree uplinkfast
VLAN port list
------------------------------------------------------------------------
1 1(fwd),2,3
Table 63 describes the fields in this display.
See Also
■ “set spantree uplinkfast” on page 341
set spantree Enables or disables STP on one VLAN or all VLANs configured on a WX
switch.
Syntax —
set spantree {enable | disable }
[{all | vlan vlan-id | port port-list vlan-id}]
■ enable — Enables STP.
■ disable — Disables STP.
■ all — Enables or disables STP on all VLANs.
■ vlan vlan-id — VLAN name or number. MSS enables or disables STP
on only the specified VLAN, on all ports within the VLAN.
■ port port-list vlan-id — Port number or list and the VLAN the
ports are in. MSS enables or disables STP on only the specified ports,
within the specified VLAN.
Defaults — Disabled.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Table 63 Output for display spantree uplinkfast
Field Description
VLAN VLAN number.
port list Ports in the uplink group. The port that is forwarding
traffic is indicated by fwd. The other ports are blocking
traffic.