302 CHAPTER 9: MANAGED ACCESS POINT COMMANDS
Microsoft Windows XP does not support WEP with WPA. To configure a
service profile to provide dynamic WEP for XP clients, leave WPA disabled
and use the set service-profile wep commands.
To support non-WPA clients that use static WEP, you must configure static
WEP keys. Use the set service-profile wep key-index command.
Examples — The following command configures service profile sp2 to
use 104-bit WEP encryption:
WX4400# set service-profile sp2 cipher-wep104 enable
success: change accepted.
See Also
■ “set service-profile cipher-ccmp” on page 299
■ “set service-profile cipher-tkip” on page 300
■ “set service-profile cipher-wep40” on page 302
■ “set service-profile wep key-index” on page 311
■ “set service-profile wpa-ie” on page 312
set service-profile
cipher-wep40
Enables dynamic Wired Equivalent Privacy (WEP) with 40-bit keys, in a
service profile.
Syntax —
set service-profile name cipher-wep40 {enable |
disable}
■ name — Service profile name.
■ enable — Enables 40-bit WEP encryption for WPA clients.
■ disable — Disables 40-bit WEP encryption for WPA clients.
Defaults — 40-bit WEP encryption is disabled by default.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — To use 40-bit WEP with WPA clients, you must also enable the
WPA IE.
To Next Page
Loading...
