3Com 3CRWX120695A - Display {Ap | Dap} Group

242 CHAPTER 9: MANAGED ACCESS POINT COMMANDS
display {ap | dap}
group
Displays configuration information and load-balancing status for MAP
access point groups.
Syntax —
display {ap | dap} group [name]
■ name — Name of an MAP group or Distributed MAP group.
Defaults — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Examples — The following command displays information for MAP
access point group loadbalance1:
WX1200# display ap group loadbalance1
Load Balance Grp Port Clients Status Refused
---------------- ---- ------- --------- -------
loadbalance1 1 1 Accepting 0
loadbalance1 6 6 Refusing 2
Table 48 describes the fields in this display.
TxCarrierLoss Number of frames transmitted despite the detection of a
deassertion of CRS during the transmission.
TxDeferred Number of frames deferred before transmission due to
activity on the link.
Table 47 Output of display ap etherstats (continued)
Field Description
Table 48 Output for display ap group
Field Description
Load Balance Grp Name of the MAP access point group.
Port WX port number.
Clients Number of active client sessions on the MAP access point.