3Com 3CRWX120695A - Distributing WX Configuration Files

set ntp update-interval 149
set ntp
update-interval
Changes how often MSS sends queries to the NTP servers for updates.
Syntax —
set ntp update-interval seconds
■ seconds — Number of seconds between queries. You can specify
from 16 through 1,024 seconds.
Default — The default NTP update interval is 64 seconds.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Examples — The following command changes the NTP update interval
to 128 seconds:
WX4400# set ntp update-interval 128
success: change accepted.
See Also
■ “clear ntp server” on page 113
■ “clear ntp update-interval” on page 113
■ “display ntp” on page 125
■ “set ntp” on page 147
■ “set ntp server” on page 148
set snmp
community
Names the SNMP read and read-write communities, which allow remote
wireless LAN switches to access management information base (MIB)
objects on a WX switch.
Syntax —
set snmp community {read-only | read-write}
comm-string
■ read-only — Allows the specified community string read access only.
■ read-write — Allows the specified community string read and write
access.
■ comm-string — Name of the SNMP community. Specify between 1
and 256 alphanumeric characters, with no spaces.
Default — None.