3Com 3CRWX120695A - Set {Ap | Dap} Radio Tx-Power

set {ap | dap} radio tx-power 273
■ mode disable — Disables radios on the specified ports.
Defaults — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — When you create a new profile, the radio parameters in the
profile are set to their factory default values.
To enable or disable all radios that use a specific radio profile, use set
radio-profile.
Examples — The following command enables radio 1 on ports 3
through 6 assigned to radio profile rp1:
WX1200# set ap 3-6 radio 1 radio-profile rp1 mode enable
success: change accepted.
See Also
■ “clear {ap | dap} radio” on page 232
■ “display radio-profile” on page 254
■ “set {ap | dap} radio mode” on page 271
■ “set radio-profile mode” on page 287
set {ap | dap} radio
tx-power
Sets an MAP radio’s transmit power.
Syntax —
set {ap port-list | dap dap-num} radio {1 | 2}
tx-power power-level
■ ap port-list — List of ports connected to the MAP access points on
which to set the transmit power.
■ dap dap-num — Number of a Distributed MAP on which to set the
transmit power.
■ radio 1 — Radio 1 of the MAP.
■ radio 2 — Radio 2 of the MAP. (This option does not apply to
single-radio models.)