452 CHAPTER 17: RF DETECTION COMMANDS
See Also
■ “display rfdetect ignore” on page 455
■ “set rfdetect ignore” on page 461
display rfdetect
countermeasures
Displays the current status of countermeasures against rogues in the
Mobility Domain.
Syntax —
display rfdetect countermeasures
Defaults — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — This command is valid only on the seed switch of the Mobility
Domain.
Examples — The following example displays countermeasures status for
the Mobility Domain managed by this seed switch:
WX1200# display rfdetect countermeasures
Total number of entries: 8
Rogue MAC Countermeasures WX-IPaddr Port/Radio
Radio Mac /Channel
----------------- ------------------ --------------- -------------
00:00:00:01:7a:80 00:0b:0e:00:0a:a3 10.8.121.101 5/2/60
00:0b:0e:08:1a:01 Not Started
00:0b:0e:01:00:00 Not Started
00:0b:0e:00:03:80 00:0b:0e:00:0a:6a 10.8.121.102 3/1/1
00:0b:0e:00:d1:00 00:0b:0e:00:0a:6a 10.8.121.102 3/1/11
00:0b:0e:00:7a:80 00:0b:0e:00:0a:6b 10.8.121.102 3/2/60
00:06:25:51:e9:ff Not Started
00:0b:0e:01:08:40 00:0b:0e:00:0a:6a 10.8.121.102 3/1/1
Table 85 describes the fields in this display.
To Next Page
Loading...
