484 CHAPTER 19: TRACE COMMANDS
save trace Saves the accumulated trace data for enabled traces to a file in the WX
switch’s nonvolatile storage.
Syntax —
save trace filename
■ filename — Name for the trace file. To save the file in a subdirectory,
specify the subdirectory name, then a slash. For example: traces/trace1
Defaults — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Examples — To save trace data into the file trace1 in the subdirectory
traces, type the following command:
WX4400# save trace traces/trace1
set trace
authentication
Traces authentication information.
Syntax —
set trace authentication [mac-addr mac-address]
[port port-num] [user username] [level level]
■ mac-addr mac-address — Traces a MAC address. Specify a MAC
address, using colons to separate the octets (for example,
00:11:22:aa:bb:cc).
■ port port-num — Traces on a WX port number.
■ user username — Traces a user. Specify a username of up to
32 alphanumeric characters with no spaces.
■ level level — Determines the quantity of information included in
the output. You can set the level with an integer from 1 to 10, where
level 10 provides the most information. Levels 1 through 5 provide
user-readable information. If you do not specify a level, level 5 is the
default.
Defaults — The default trace level is 5.
Access — Enabled.
History — Introduced in MSS Version 3.0.
To Next Page
Loading...
