3Com 3CRWX120695A - Clear Sessions Network

436 CHAPTER 16: SESSION MANAGEMENT COMMANDS
Defaults — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Examples — To clear all administrator sessions type the following
command:
WX4400# clear sessions admin
This will terminate manager sessions,
do you wish to continue? (y|n) [n]y
To clear all administrative sessions through the console, type the
following command:
WX4400# clear sessions console
This will terminate manager sessions,
do you wish to continue? (y|n) [n]y
To clear all administrative Telnet sessions, type the following command:
WX4400# clear sessions telnet
This will terminate manager sessions,
do you wish to continue? (y|n) [n]y
To clear Telnet client session 0, type the following command:
WX4400# clear sessions telnet client 0
See Also
■ “display sessions” on page 438
clear sessions
network
Clears all network sessions for a specified username or set of usernames,
MAC address or set of MAC addresses, virtual LAN (VLAN) or set of
VLANs, or session ID.
Syntax —
clear sessions network {user user-glob | mac-addr
mac-addr-glob | vlan vlan-glob | session-id local-session-id}
■ user user-glob — Clears all network sessions for a single user or set
of users.
Specify a username, use the double-asterisk wildcard character (**) to
specify all usernames, or use the single-asterisk wildcard character (*)
to specify a set of usernames up to or following the first delimiter