display {ap | dap} status 243
See Also
■ “set {ap | dap} group” on page 263
display {ap | dap}
status
Displays MAP access point and radio status information.
Syntax — display ap status [port-list | all [radio {1 | 2}]]
Syntax — display dap status [dap-num [radio {1 | 2}]]
■ port-list — List of ports connected to the MAP access point(s) for
which to display status.
■ dap-num — Number of a Distributed MAP for which to display status.
■ all — Shows status information for all directly attached MAP access
points and all Distributed MAP access points configured on the switch.
■ radio 1 — Shows status information for radio 1.
■ radio 2 — Shows status information for radio 2. (This option does
not apply to single-radio models.)
Defaults — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Status Association status of the MAP access point:
■ Accepting — The MAP access point is accepting new
associations.
■ Refusing — The MAP access point is refusing new
associations.
Refused Number of association requests refused by the MAP access
point due to load balancing. MSS resets this counter to 0
when the WX switch is restarted, MSS is reloaded, or the
access point is removed from the group.
Table 48 Output for display ap group (continued)
Field Description
To Next Page
Loading...
