set igmp 355
See Also
■ “clear igmp statistics” on page 344
set igmp Disables or reenables IGMP snooping on one VLAN or all VLANs on a
wireless LAN switch.
Syntax —
set igmp {enable | disable} [vlan vlan-id]
■ enable — Enables IGMP snooping.
■ disable — Disables IGMP snooping.
■ vlan vlan-id — VLAN name or number. If you do not specify a
VLAN, IGMP snooping is disabled or reenabled on all VLANs.
History — Introduced in MSS Version 3.0.
Examples — The following command disables IGMP snooping on VLAN
orange:
WX1200# set igmp disable vlan orange
success: change accepted
See Also
■ “set igmp rv” on page 364
Topology
notifications
Number of Layer 2 topology change notifications received by the
WX.
In the current software version, the value in this field is always 0.
Packets with
unknown
IGMP type
Number of multicast packets received with an unrecognized
multicast type.
Packets with
bad length
Number of packets with an invalid length.
Packets with
bad IGMP
checksum
Number of packets with an invalid IGMP checksum value.
Packets
dropped
Number of multicast packets dropped by the WX.
Table 69 Output of display igmp statistics (continued)
Field Description
To Next Page
Loading...
