3Com 3CRWX120695A - Display Service-Profile

display service-profile 257
See Also
■ “set radio-profile 11g-only” on page 275
■ “set radio-profile auto-tune channel-config” on page 276
■ “set radio-profile auto-tune channel-holddown” on page 277
■ “set radio-profile auto-tune channel-interval” on page 278
■ “set radio-profile auto-tune power-backoff- timer” on page 279
■ “set radio-profile auto-tune power-config” on page 280
■ “set radio-profile auto-tune power-interval” on page 281
■ “set radio-profile beacon-interval” on page 282
■ “set radio-profile dtim-interval” on page 283
■ “set radio-profile frag-threshold” on page 283
■ “set radio-profile long-retry” on page 284
■ “set radio-profile max-rx-lifetime” on page 285
■ “set radio-profile max-tx-lifetime” on page 286
■ “set radio-profile mode” on page 287
■ “set radio-profile preamble-length” on page 289
■ “set radio-profile rts-threshold” on page 290
■ “set radio-profile service-profile” on page 291
■ “set radio-profile short-retry” on page 294
display
service-profile
Displays service profile information.
Syntax — display service-profile {name | ?}
■ name — Displays information about the named service profile.
■ ? — Displays a list of service profiles.
Defaults — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Examples — The following command displays information for service
profile wpa_clients: