3
SYSTEM SERVICE COMMANDS
Use system services commands to configure and monitor system
information for a WX switch.
Commands by
Usage
This chapter presents system services commands alphabetically. Use
Table 6 to located commands in this chapter based on their use.
Table 6 System Services Commands by Usage
Type Command
Display “clear banner motd” on page 38
“set banner motd” on page 46
“display banner motd” on page 40
“set confirm” on page 47
“set length” on page 48
System Identification “set prompt” on page 50
“set system name” on page 55
“set system location” on page 54
“set system contact” on page 51
“set system countrycode” on page 51
“set system ip-address” on page 53
“display system” on page 42
“clear system” on page 39
“clear prompt” on page 39
Help “help” on page 45
History “history” on page 46
“clear history” on page 38
To Next Page
Loading...
