134 CHAPTER 6: IP SERVICES COMMANDS
Examples — The following command adds a static ARP entry that maps
IP address 10.10.10.1 to MAC address 00:bb:cc:dd:ee:ff:
WX1200# set arp static 10.10.10.1 00:bb:cc:dd:ee:ff
success: added arp 10.10.10.1 at 00:bb:cc:dd:ee:ff on VLAN 1
See Also
■ “set arp agingtime” on page 134
■ “telnet” on page 158
set arp agingtime Changes the aging timeout for dynamic ARP entries.
Syntax —
set arp agingtime seconds
■ seconds — Number of seconds an entry can remain unused before
MSS removes the entry. You can specify from 0 through 1,000,000. To
disable aging, specify 0.
Defaults — None.
Access — Enabled.
History— Introduced in MSS Version 3.0.
Usage — Aging applies only to dynamic entries.
To reset the ARP aging timeout to its default value, use the set arp
agingtime 1200 command.
Examples — The following command changes the ARP aging timeout to
1800 seconds:
WX1200# set arp agingtime 1800
success: set arp aging time to 1800 seconds
The following command disables ARP aging:
WX1200# set arp agingtime 0
success: set arp aging time to 0 seconds
See Also
■ “set arp” on page 133
■ “telnet” on page 158
To Next Page
Loading...
