300 CHAPTER 9: MANAGED ACCESS POINT COMMANDS
■ enable — Enables CCMP encryption for WPA clients.
■ disable — Disables CCMP encryption for WPA clients.
Defaults — CCMP encryption is disabled by default.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — To use CCMP, you must also enable the WPA IE.
Examples — The following command configures service profile sp2 to
use CCMP encryption:
WX4400# set service-profile sp2 cipher-ccmp enable
success: change accepted.
See Also
■ “set service-profile cipher-tkip” on page 300
■ “set service-profile cipher-wep104” on page 301
■ “set service-profile cipher-wep40” on page 302
■ “set service-profile wpa-ie” on page 312
set service-profile
cipher-tkip
Disables or reenables Temporal Key Integrity Protocol (TKIP) encryption in
a service profile.
Syntax —
set service-profile
name cipher-tkip {enable | disable}
■ name — Service profile name.
■ enable — Enables TKIP encryption for WPA clients.
■ disable — Disables TKIP encryption for WPA clients.
Defaults — When the WPA IE is enabled, TKIP encryption is enabled by
default.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — To use TKIP, you must also enable the WPA IE.
To Next Page
Loading...
