306 CHAPTER 9: MANAGED ACCESS POINT COMMANDS
Examples — The following command enables the RSN IE in service
profile sprsn:
WX4400# set service-profile sprsn rsn-ie enable
success: change accepted.
See Also
■ “set service-profile cipher-ccmp” on page 299
set service-profile
shared-key-auth
Enables shared-key authentication, in a service profile.
Use this command only if advised to do so by 3Com. This command does
not enable preshared key (PSK) authentication for Wi-Fi Protected Access
(WPA). To enable PSK encryption for WPA, use the
set service-profile auth-psk command.
Syntax —
set service-profile name shared-key-auth {enable |
disable}
■ name — Service profile name.
■ enable — Enables shared-key authentication.
■ disable — Disables shared-key authentication.
Defaults — Shared-key authentication is disabled by default.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Examples — The following command enables shared-key authentication
in service profile sp4:
WX4400# set service-profile sp4 shared-key-auth enable
success: change accepted.
See Also
■ “display radio-profile” on page 254
■ “set radio-profile mode” on page 287
To Next Page
Loading...
