492 CHAPTER 20: SYSTEM LOG COMMANDS
See Also
■ “clear log” on page 489
■ “display log config” on page 492
display log config Displays log configuration information.
Syntax — display log config
Defaults — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Examples — To display how logging is configured, type the following
command:
WX4400# display log config
Logging console: disabled
Logging console severity: DEBUG
Logging sessions: disabled
Logging sessions severity: INFO
Logging buffer: enabled
Logging buffer severity: WARNING
Logging trace: enabled
Logging trace severity: DEBUG
Logging buffer size: 10485760 bytes
Logging server: 10.1.1.10 severity DEBUG
Current session: disabled
Current session severity: INFO
See Also
■ “set log” on page 494
■ “clear log” on page 489
display log trace Displays system information stored in the nonvolatile log buffer or the
trace buffer.
To Next Page
Loading...
