display log buffer 491
■ severity severity-level — Displays messages at a severity level
greater than or equal to the level specified. Specify one of the
following:
■ emergency — The WX switch is unusable.
■ alert — Action must be taken immediately.
■ critical — You must resolve the critical conditions. If the
conditions are not resolved, the WX can reboot or shut down.
■ error — The WX is missing data or is unable to form a connection.
■ warning — A possible problem exists.
■ notice — Events that potentially can cause system problems have
occurred. These are logged for diagnostic purposes. No action is
required.
■ info — Informational messages only. No problem exists.
■ debug — Output from debugging.
Defaults — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — The debug level produces a lot of messages, many of which
can appear to be somewhat cryptic. Debug messages are used primarily
by 3Com for troubleshooting and are not intended for administrator use.
Examples — Type the following command to see the facilities for which
you can view event messages archived in the buffer:
WX4400# display log buffer facility ?
<facility name> Select one of: KERNEL, AAA, SYSLOGD, ACL, APM, ARP,
ASO, BOOT, CLI, CLUSTER, COPP, CRYPTO, DOT1X, ENCAP, ETHERNET, GATEWAY, HTTPD,
IGMP, IP, MISC, NOSE, NP, RAND, RESOLV, RIB, ROAM, ROGUE, SM, SNMPD, SPAN, STORE,
SYS, TAGMGR, TBRIDGE, TCPSSL, TELNET, TFTP, TLS, TUNNEL, VLAN, X509, XML, MAP,
RAPDA, WEBVIEW, EAP, PORTCONFIG, FP.
The following command displays logged messages for the AAA facility:
WX4400# display log buffer facility AAA
AAA Jun. 25 09:11:32.579848 ERROR AAA_NOTIFY_ERR: AAA got SM
special event (98) on locality 3950 which is gone
To Next Page
Loading...
