5
VLAN COMMANDS
Use virtual LAN (VLAN) commands to configure and manage parameters
for individual port VLANs on network ports, and to display information
about clients roaming within a mobility domain.
Commands by
usage
This chapter presents V
LAN comm
ands alphabetically. Use Table 19 to
locate commands in this chapter based on their use.
Table 19 VLAN Commands by Usage
Type Command
Creation “clear fdb” on page 90
Ports “set vlan port” on page 104
“clear vlan” on page 91
“display vlan config” on page 99
Roaming and Tunnels “display roaming station” on page 96
“display roaming vlan” on page 97
“display tunnel” on page 98
Tunnel Affinity “set vlan tunnel-affinity” on page 105
FDB Entries “set fdb” on page 101
“display fdb” on page 92
“display fdb count” on page 95
“clear fdb” on page 90
FDB Aging Timeout “set fdb agingtime” on page 102
“display fdb agingtime” on page 94
To Next Page
Loading...
