3Com 3CRWX120695A - Clear Dot1 X Reauth-Period; Clear Dot1 X Timeout Auth-Server

clear dot1x reauth-period 419
Access — Enabled.
History — Introduced in MSS Version 3.0.
Examples — Type the following command to reset the maximum
number of reauthorization attempts to the default:
WX4400# clear dot1x reauth-max
success: change accepted.
See Also
■ “display dot1x” on page 421
■ “set dot1x reauth-max” on page 430
clear dot1x
reauth-period
Resets the time period that must elapse before a reauthentication
attempt, to the default time period.
Syntax —
clear dot1x reauth-period
Defaults — The default is 3600 seconds (1 hour).
Access — Enabled.
History — Introduced in MSS Version 3.0.
Examples — Type the following command to reset the default
reauthentication time period:
WX4400# clear dot1x reauth-period
success: change accepted.
See Also
■ “display dot1x” on page 421
■ “set dot1x reauth-period” on page 430
clear dot1x timeout
auth-server
Resets to the default setting the number of seconds that must elapse
before the WX times out a request to a RADIUS server.
Syntax —
clear dot1x timeout auth-server
Defaults — The default is 30 seconds.