3Com 3CRWX120695A - Apply a Radio Profile to Each Radio; What’s Next?

98 CHAPTER 5: VLAN COMMANDS
Syntax — display roaming vlan
Default — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Examples — The following command shows the current roaming
VLANs:
WX4400# display roaming vlan
VLAN WX Affinity
---------------- --------------- --------
vlan-cs 192.168.14.2 5
vlan-eng 192.168.14.4 5
vlan-fin 192.168.14.2 5
vlan-it 192.168.14.4 5
vlan-it 192.168.14.2 5
vlan-pm 192.168.14.2 5
vlan-sm 192.168.14.2 5
vlan-tp 192.168.14.4 5
vlan-tp 192.168.14.2 5
Table 22 describes the fields in the display.
See Also
■ “display roaming station” on page 96
■ “display vlan config” on page 99
display tunnel Shows the tunnels from the wireless LAN switch where you type the
command.
Syntax —
display tunnel
Table 22 Output for display roaming vlan
Field Description
VLAN VLAN name.
WX System IP address of the wireless LAN switch on which the
VLAN is configured.
Affinity Preference of this WX switch for forwarding user traffic for
the VLAN. A higher number indicates a greater preference.