3Com 3CRWX120695A - Set {Ap | Dap} Name

264 CHAPTER 9: MANAGED ACCESS POINT COMMANDS
Examples — The following command configures an MAP access point
group named loadbalance1 that contains the MAP access points on ports
1, 3, and 5:
WX1200# set ap 1,3,5 group loadbalance1
success: change accepted.
The following command removes the MAP access point on port 4 from all
MAP access point groups:
WX1200# set ap 4 group none
success: change accepted.
See Also
■ “display {ap | dap} config” on page 234
■ “display {ap | dap} group” on page 242
set {ap | dap} name Changes an MAP name.
Syntax —
set {ap port-list | dap dap-num} name name
■ ap port-list — List of ports connected to the MAP access point to
rename.
■ dap dap-num — Number of a Distributed MAP to rename.
■ name — Alphanumeric string of up to 16 characters, with no spaces.
Defaults — The default name of a directly attached MAP is based on the
port number of the MAP access port attached to the MAP. For example,
the default name for a MAP on MAP access port 1 is MAP01. The default
name of a Distributed MAP is based on the number you assign to it when
you configure the connection. For example, the default name for
Distributed MAP 1 is DMP01.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Examples — The following command changes the name of the MAP
access point on port 1 to techpubs:
WX1200# set ap 1 name techpubs
success: change accepted.