set mobility-domain mode member seed-ip 227
Defaults — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — This command must be entered from the seed WX switch.
Examples — The following commands add three WX switches with the
IP addresses 192.168.1.8, 192.168.1.9, and 192.168.1.10 as members of
a Mobility Domain whose seed is the current WX switch:
WX4400# set mobility-domain member 192.168.1.8
success: change accepted.
WX4400# set mobility-domain member 192.168.1.9
success: change accepted.
WX4400# set mobility-domain member 192.168.1.10
success: change accepted.
See Also
■ “clear mobility-domain member” on page 224
■ “display mobility-domain config” on page 225
■ “set mobility-domain mode seed domain-name” on page 228
set
mobility-domain
mode member
seed-ip
On a nonseed WX switch, sets the IP address of the seed WX switch. This
command is used on a member WX to configure it as a member. If the
WX switch is currently part of another Mobility Domain or using another
seed, this command overwrites that configuration.
Syntax —
set mobility-domain mode member seed-ip ip-addr
■ ip-addr — IP address of the Mobility Domain member, in dotted
decimal notation.
Defaults — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Examples — The following command sets the current WX switch as a
nonseed member of the Mobility Domain whose seed has the IP address
192.168.1.8:
To Next Page
Loading...
