3Com 3CRWX120695A - Display Rfdetect Ignore; Display Rfdetect Mobility-Domain

display rfdetect ignore 455
display rfdetect
ignore
Displays the BSSIDs of third-party devices that MSS ignores during RF
scans. MSS does not generate log messages or traps for the devices in the
ignore list.
Syntax —
display rfdetect ignore
Defaults — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Examples — The following example displays the list of ignored devices:
WX4400# display rfdetect ignore
Total number of entries: 2
Ignore MAC
-----------------
aa:bb:cc:11:22:33
aa:bb:cc:44:55:66
See Also
■ “clear rfdetect ignore” on page 451
■ “set rfdetect ignore” on page 461
display rfdetect
mobility-domain
Displays the rogues detected by all WX switches in the Mobility Domain
during RF detection scans.
Syntax —
display rfdetect mobility-domain
Defaults — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — This command is valid only on the seed switch of the Mobility
Domain. To display rogue information for an individual switch, use the
display rfdetect data command on that switch.
Only rogues are listed. To display all devices detected, including 3Com
radios, use the display rfdetect data command.