454 CHAPTER 17: RF DETECTION COMMANDS
Only one MAC address is listed for each 3Com radio, even if the radio is
beaconing multiple SSIDs.
Examples — The following command shows the devices detected by this
WX switch during the most recent RF detection scan:
WX1200# display rfdetect data
Total number of entries: 7
BSSID Port/Rad Chan RSSI Age SSID
----------------- -------- ------ ---- --- --------
00:06:25:09:39:4a 5/1 3 0 15 rack29-hostap
00:06:25:51:e9:ff 4/1 10 -85 15 Arrow
00:06:25:51:e9:ff 5/1 10 -84 15 Arrow
00:0b:0e:00:00:00 4/1 1 -78 15 gary-eng
00:0b:0e:00:02:00 4/1 11 -76 15 public
00:0b:0e:00:02:00 5/1 11 -74 15 public
00:0b:0e:00:02:01 4/1 56 -68 15 public
Table 86 describes the fields in this display.
See Also
■ “display rfdetect mobility-domain” on page 455
■ “display rfdetect visible” on page 457
Table 86 display rfdetect data Output
Field Description
BSSID BSSID detected by a MAP radio on this WX switch.
Port/Rad MAP and radio MAP that detected the BSSID.
For a directly connected MAP, the MAP port number and
radio number are listed. For a Distributed MAP, the
connection number and radio number are listed.
Chan Number of the channel on which the MAP radio detected
the BSSID.
RSSI Received signal strength indication (RSSI) — the strength of
the RF signal detected by the MAP radio, in decibels referred
to 1 milliwatt (dBm).
Age Age of the rogue listing, in seconds. Rogues age out of the
rogue list after one minute.
SSID Service set identifier (SSID) associated with the BSSID.
To Next Page
Loading...
