display auto-tune neighbors 249
Information is displayed for a radio if the radio sends beacon frames or
responds to probe requests. Even if a radio’s SSIDs are unadvertised,
3Com radios detect the empty beacon frames (beacon frames without
SSIDs) sent by the radio, and include the radio in the neighbor list.
Examples — The following command displays neighbor information for
radio 1 on the directly connected MAP access point on port 2:
WX1200# display auto-tune neighbors ap 2 radio 1
Total number of entries for port 2 radio 1: 5
Channel Neighbor BSS/MAC RSSI
------- ----------------- ----
1 00:0b:85:06:e3:60 -46
1 00:0b:0e:00:0a:80 -78
1 00:0b:0e:00:d2:c0 -74
1 00:0b:85:06:dd:00 -50
1 00:0b:0e:00:05:c1 -72
Table 51 describes the fields in this display.
See Also
■ “display auto-tune attributes” on page 246
■ “display radio-profile” on page 254
■ “set {ap | dap} radio auto-tune max-power” on page 266
■ “set {ap | dap} radio auto-tune max- retransmissions” on page 267
■ “set radio-profile auto-tune channel-config” on page 276
■ “set radio-profile auto-tune channel-holddown” on page 277
■ “set radio-profile auto-tune channel-interval” on page 278
■ “set radio-profile auto-tune power-backoff- timer” on page 279
■ “set radio-profile auto-tune power-config” on page 280
■ “set radio-profile auto-tune power-interval” on page 281
Table 51 Output for display auto-tune neighbors
Field Description
Channel Channel on which the BSSID is detected.
Neighbor BSS/MAC BSSID detected by the radio.
RSSI Received signal strength indication (RSSI), in decibels referred
to 1 milliwatt (dBm). A higher value indicates a stronger
signal.
To Next Page
Loading...
