236 CHAPTER 9: MANAGED ACCESS POINT COMMANDS
AP model MAP access point model number.
POE PoE state on the WX port:
■ Enable
■ Disable
bias Bias of the WX connection to the MAP:
■ High
■ Low
name MAP access point name.
boot-download-
enable
State of the firmware upgrade option:
■ YES (automatic upgrades are enabled)
■ NO (automatic upgrades are disabled)
load balancing group Names of the MAP load-balancing groups to which the MAP
access point belongs. If the value is None, the access point
does not belong to any load balancing groups.
Note: This field is displayed only if the MAP is a member of a
group.
Radio Radio number. The information listed below this field applies
specifically to the radio.
type Radio type:
■ 802.11a
■ 802.11b
■ 802.11g
mode Radio state:
■ Enabled
■ Disabled
channel Channel number.
antennatype External antenna model, if applicable.
tx pwr Transmit power, in dBm.
profile Radio profile that manages the radio. Until you assign the
radio to a radio profile, MSS assigns the radio to the default
radio profile.
Table 45 Output for display ap config (continued)
Field Description
To Next Page
Loading...
