set radio-profile service-profile 293
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — You must configure the service profile before you can map it to
a radio profile. You can map the same service profile to more than one
radio profile.
You must disable all radios that use a radio profile before you can change
parameters in the profile. Use the set radio-profile mode command
.
Examples — The following command maps service-profile wpa_clients
to radio profile rp2:
WX4400# set radio-profile rp2 service-profile wpa_clients
success: change accepted.
See Also
■ “display service-profile” on page 257
■ “set service-profile auth-dot1x” on page 295
■ “set service-profile auth-fallthru” on page 296
■ “set service-profile auth-psk” on page 298
■ “set service-profile beacon” on page 299
■ “set service-profile cipher-ccmp” on page 299
■ “set service-profile cipher-tkip” on page 300
wep key-index No keys
defined
Uses dynamic WEP rather than static WEP.
If you configure a WEP key for static WEP,
MSS continues to also support dynamic
WEP.
wep active-
multicast-index
1 Uses WEP key 1 for static WEP encryption
of multicast traffic if WEP encryption is
enabled and keys are defined.
wep active-unicast-
index
1 Uses WEP key 1 for static WEP encryption
of unicast traffic if WEP encryption is
enabled and keys are defined.
wpa-ie disable Does not use the WPA IE in transmitted
frames.
Table 58 Defaults for Service Profile Parameters (continued)
Parameter Default Value
Radio Behavior When Parameter Set
to Default Value
To Next Page
Loading...
