set service-profile wpa-ie 313
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — When the WPA IE is enabled, the default authentication
method is 802.1X. There is no default cipher suite. You must enable the
cipher suites you want the radios to support.
Examples — The following command enables the WPA IE in service
profile sp2:
WX4400# set service-profile sp2 wpa-ie enable
success: change accepted.
See Also
■ “set service-profile auth-dot1x” on page 295
■ “set service-profile auth-psk” on page 298
■ “set service-profile cipher-ccmp” on page 299
■ “set service-profile cipher-tkip” on page 300
■ “set service-profile cipher-wep104” on page 301
■ “set service-profile cipher-wep40” on page 302
To Next Page
Loading...
