set server group load-balance 413
Examples — To enable load balancing between the members of server
group shorebirds, type the following command:
WX1200# set server group shorebirds load-balance enable
success: change accepted.
To disable load balancing between shorebirds server group members,
type the following command:
WX1200# set server group shorebirds load-balance disable
success: change accepted.
See Also
■ “clear server group” on page 406
■ “clear radius server” on page 405
■ “display aaa” on page 180
■ “set server group” on page 411
To Next Page
Loading...
