display fdb 93
■ perm — Displays permanent entries. A permanent entry does not age
out and remains in the database even after a reboot, reset, or power
cycle.
■ static — Displays static entries. A static entry does not age out, but
is removed from the database after a reboot, reset, or power cycle.
■ dynamic — Displays dynamic entries. A dynamic entry is automatically
removed through aging or after a reboot, reset, or power cycle.
■ system — Displays system entries. A system entry is added by MSS.
For example, the authentication protocols can add entries for wired
and wireless authentication users.
■ all — Displays all entries in the database, or all the entries that match
a particular port or ports or a particular VLAN.
■ port port-list — Destination port(s) for which to display entries.
Default — None.
Access — All.
History — Introduced in MSS Version 3.0.
Usage — To display the entire forwarding database, enter the display
fdb command without options. To display only a portion of the database,
use optional parameters to specify the types of entries you want to
display.
Examples — The following command displays all entries in the
forwarding database:
WX4400# display fdb all
* = Static Entry. + = Permanent Entry. # = System Entry.
VLAN TAG Dest MAC/Route Des [CoS] Destination Ports [Protocol Type]
---- ---- ------------------ ----- -----------------------------------------
1 00:01:97:13:0b:1f 1 [ALL]
1 aa:bb:cc:dd:ee:ff * 3 [ALL]
1 00:0b:0e:02:76:f5 1 [ALL]
Total Matching FDB Entries Displayed = 3
The top line of the display identifies the characters to distinguish among
the entry types.
To Next Page
Loading...
