3Com SuperStack II - Displaying Menus; Obtaining Help

100 C
HAPTER
4: W
ORKING
W
ITH THE
C
OMMAND
L
INE
I
NTERFACE
■
To enter multiple commands:
At the prompt, enter each command in succession. For example, to
display the system menu and reset the Switch units in the stack, enter:
system reset
■
To enter commands that require values:
Append the values to the name of the command. For example, to
display the system menu and change your password, enter:
system password <password>
If you do not specify values for a command that requires them, you
are prompted to enter the values. At each prompt, the default value is
displayed in brackets.
■
To enter abbreviated commands
At the prompt, enter enough characters to uniquely identify the
commands. For example, to display the system menu and then change
the password for your user, enter:
sy pa <password>
Displaying Menus
There are several ways to display the menus in the command line
interface menu structure:
■
To display sub-menus:
At the Select menu option prompt, enter the name of the menu or
menus.
■
To display parent menus:
At the Select menu option prompt, enter
q
.
■
To display the Top-level menu:
Press the [Esc] key.
Obtaining Help
You can access the command line interface help system at any time by
entering
?
at the Select menu option prompt.