EasyManuals Logo

3Com SuperStack II Guide

3Com SuperStack II
248 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #120 background imageLoading...
Page #120 background image
120 C
HAPTER
4: W
ORKING
W
ITH
THE
C
OMMAND
L
INE
I
NTERFACE
Displaying and
Changing Port
Information
You can display and change information about the ports on the current
Switch unit in the stack using the commands on the Ethernet menu.
These commands allow you to:
Enable and disable Ethernet ports on the Switch
Specify the speed and duplex mode of Ethernet ports on the Switch
Enable and disable auto-negotiation for Ethernet ports on the Switch
Enable and disable IEEE 802.3x flow control for Ethernet ports on the
Switch
Display statistical information about Ethernet ports on the Switch
Display summary information about Ethernet ports on the Switch
To display and change information about the ports on another Switch
unit in the stack, you need to select that unit using the
unit
command
For more information, see
Moving the Focus of the Command Line
Interface
on
page 141
.
Enabling and
Disabling Ports
You can enable and disable Ethernet ports on the Switch using the
portState
command on the Ethernet menu.
By default, all ports on the Switch are enabled.
To enable or disable a port:
1
At the Top-level menu, enter:
ethernet portState
The following prompt is displayed:
Select Ethernet port(s) (1-24):
2
Enter the number of the port to be enabled or disabled.
The following prompt is displayed:
Enter new value (enable, disable) [enable]:
3
Enter
enable
or
disable
.

Table of Contents

Other manuals for 3Com SuperStack II

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the 3Com SuperStack II and is the answer not in the manual?

3Com SuperStack II Specifications

General IconGeneral
Brand3Com
ModelSuperStack II
CategorySwitch
LanguageEnglish

Related product manuals